Disposal; Spare Parts; Designation Of Parts - Calpeda Nmx Bedienungsanleitung

8.4. Pumps with IP 55 protection (Special con-
struction)
OFF
EN
To always assure IP 55 degree of protection, it is
necessary to check the following points:
- Before starting the motors, carefully control the
position of the gasket between terminal box and
its cover. For cable of small size, use a protective
covering between cable and cable gland.
- When disassembling the end shields of the motors,
restore the existing joint using the sealing glue
LOCTITE type 510 or other equivalent sealing
system, if any, and check the perfect assembly of the
sealing ring on the shaft.

9. DISPOSAL

OFF
The final disposal of the device must be done by
specialized company.
Make sure the specialized company follows the
classification of the material parts for the separation.
Observe the local regulations and dispose the device
accordingly with the international rules for environment
protection.

10. SPARE PARTS

10.1. Spare-parts request
When ordering spare parts, please quote their
designation, position number in the cross section
drawing and rated data from the pump name plate
(type, date and serial number).
The spare parts request shall be sent to CALPEDA
S.p.A. by phone, e-mail.

11. DESIGNATION OF PARTS

Nr. Designation
14.00 Pump casing
14.04 Plug (filling)
14.06 O-ring
14.12 Plug (draining)
14.16 O-ring
14.20 O-ring
14.24 Screw
14.54 O-ring
28.00 Impeller
28.04 Impeller nut
28.12 Circlip
28.20 Impeller key
34.00 Casing cover
36.00 Mechanical seal
46.00 Deflector
70.00 Lantern bracket
73.00 Pump-side bearing
73.08 V-Ring (IP55)
76.00 Motor casing with winding
76.04 Cable gland
76.06 Lock nut
76.16 Support
Page 14 / 80
European Directive
2012/19/EU (WEEE)
76.20 Pin
76.54 Terminal box, set
78.00 Shaft with rotor packet
81.00 Fan-side bearing
82.00 Motor end shield, fan side
82.04 Compensating spring
88.00 Motor fan
90.00 Fan cover
90.04 Screw
92.00 Tie-bolt
94.00 Capacitor
94.02 Capacitor gland
98.00 Terminal box cover
98.04 Screw
98.08 Gasket
99.00 Motor, complete
Changes reserved.
NMX Rev100000286_01 - Operating Instructions