Operation; A) Removing The Car Body; B) Installing The Receiver Aerial Cable; C) Inserting The Driving Battery Into The Vehicle - Reely 23 72 14 Bedienungsanleitung



8. Operation

a) Removing the Car Body

The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be lifted off.

b) Installing the Receiver Aerial Cable

The receiver's aerial cable is normally rolled up on delivery. Unwrap the aerial cable completely and smoothen it
carefully. For this, hold the aerial cable near the receiver with two fingers (do not hold the receiver but the cable) and
then pull the cable straight repeatedly with two fingers of your other hand.
Now insert the aerial cable from below through the attachment (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed, it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not enter the drive. Never shorten the aerial cable! Never roll up the
aerial cable! This reduces the range extremely.
c) Inserting the Driving Batteries in the Vehicle
Pull off the two safety clips on the battery holder mounting brace and then lift them off.
Insert the driving batteries into the chassis battery holder and then attach the mounting braces with the safety clips
previously removed.
The vehicle is delivered with two differently-shaped pairs of mounting braces. This makes it possible to
insert both rectangular rechargeable LiPo batteries and traditional NiMH racing packs (build 2x3 cells) into
the vehicle's battery holder.
Attention!
The drive batteries must not be connected to the speed controller yet.

d) Attaching the Telescopic Aerial to the Transmitter

If the telescopic aerial is included with the transmitter separately, insert it into the corresponding transmitter opening
from above and screw it tight by hand. Do not use any force when screwing on the aerial and do not use any tools!
44