After Using The Appliance - Bosch MMB21 Series Gebrauchsanleitung

Preparation
■ Before operating the appliance and
accessories for the first time, clean
t horoughly; see "Cleaning and servicing".
■ Place motor block on smooth, stable and
clean base.
■ Unwind the cable to the required length.
Working with the plastic blender
jug (MMB21...)
Fig. B
■ Attach blender jug to the drive on the
motor block. Arrow on the blender jug
points towards the dot on the motor
block.
■ Attach blender jug by turning it all the
way clockwise.
■ Add ingredients.
■ Put lid on and press down all the way.
Insert measuring cup into feed tube.
■ Insert the mains plug.
■ Turn rotary switch to the required
operating speed.
■ Grip the edge of the lid while operating
the blender. Do not grip the feed tube!
Add more ingredients
■ Set the rotary switch to P.
Either
■ Remove lid.
■ Add more ingredients.
or
■ Take out measuring cup.
■ Add liquids and solid (fairly small) ingre-
dients through the feed tube in the lid.
■ Switch on appliance again.

After using the appliance

■ Set the rotary switch to P.
■ Remove mains plug.
■ Remove the blender by rotating it in an
anti-clockwise direction.
■ Take the lid off the blender jug.
■ Empty blender jug.
■ Clean all parts, see "Cleaning and
servicing".
Working with the glass blender
jug (MMB42...)
Fig. C
■ Put blender jug down with the base face
up.
■ Place seal on the blade holder. Ensure
that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly posi-
tioned, liquid may run out.
■ Grip blade holder by the handle and
insert into the blender jug.
Note shape of the parts (Fig. C-2a)!
■ Move handle (Fig. C-2b). This locks the
blade holder in the blender jug.
■ Turn blender jug over.
■ Attach blender jug to the drive on the
motor block. Arrow on the blender jug
points towards the dot on the motor block.
■ Attach blender jug by turning it all the
way clockwise.
■ Add ingredients.
■ Put lid on and press down all the way.
Insert measuring cup into feed tube.
■ Insert the mains plug.
■ Turn rotary switch to the required
operating speed.
■ Grip the edge of the lid while operating
the blender. Do not grip the feed tube!
Add more ingredients
■ Set the rotary switch to P.
Either
■ Remove lid.
■ Add more ingredients.
or
■ Take out measuring cup.
■ Add liquids and solid (fairly small) ingre-
dients through the feed tube in the lid.
■ Switch on appliance again.
After using the appliance
■ Set the rotary switch to P.
■ Remove mains plug.
■ Remove the blender jug by rotating it in
an anti-clockwise direction.
■ Take the lid off the blender jug.
■ Empty blender jug.
■ Turn blender jug over and put down with
the opening face down.
Operation en
15