Unpacking Your Ice Maker - Homcom 800-293V70 Bedienungsanleitung

EN
35 Rear plate
36 Water supplying pipe
37 Magnetic control switch
38 Water drainage port
39 Water dividing pipe, with nine holes ABS
40 Evaporator and its frame
41 Cap of the water dividing pipe
42 Ice-full detecting plate
43 Top cover
44 Insulation sponge of the top cover
Foaming inner cabinet & Ice storing
45
bin
OPERATING PROCEDURES & MAINTENANCE

UNPACKING YOUR ICE MAKER

1. Remove the exterior and interior packaging. Check if all the accessories, including
instruction manual, ice scoop, white water inlet pipe, 4 ways to 2 ways water quick
connector and the water draining pipe, etc., are inside or not. If any parts are missing,
please contact our customer service.
2. Remove the tapes for fixing the door and inner cabinet, ice scoop, etc.. Roughly clean
the inner cabinet & ice scoop with wet clothe.
3. Put the ice maker on a level & flat floor, without direct sunlight and other sources of
heat (i.e.: stove, furnace, radiator). Maker sure that there is at least 20cm gap
between the air outlet and the obstacles, and at least 5 cm between Left/Right side
and the wall.
4. Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in if the
unit maybe fall upside down during shipping or transportation.
5. The appliance must be positioned so that the plug is accessible.
WARNING
: connect to the potable water supplying only. Only use drinking water.
INSTALLATION LOCATION REQUIREMENT
a) This unit is not for outdoor use. Keep the proper room temperature and inlet water
temperature according to above specification table. Otherwise it will affect the ice
making performance.
b) This unit should not be located near any heat resource.
c) The unit should be located on a firm & level foundation at normal counter top height.
Zinc-plated steel
Silicone pipe
DC5V, Electrical parts
ABS
Copper plated with nickle, and ABS
frame
Silicone
ABS
Stainless steel
PE
HIPS and Cyclopentane foaming
10
1
1
2
1
1
1
1
1
1
1
1