HOMCOM 800-293V70 Bedienungsanleitung Seite 23

EN
Ice cube is very
thin
Ice cube is too
thick
" "indicator is
on.
Ice making cycle
is normal, but
there is no ice
cube produced
ERROR INDICATOR
a) Ambient temp sensor breakdown Display E1 in digital window.
b) The machine not make ice or the gas leak Display E2 in digital window.
c) Magnetic control switch cut off----"Full" light will be on when plugging on or just
turning on the unit. And it will delete the breakdown display if this switch is electric
shorted.
d) During the ice making process, press the "ON/OFF" button for more than 5
seconds, the unit start to enter the ice harvest program. And after the ice harvest
program, it continue to enter the ice making process.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Ambient temperature is too
high
Air circulation around the
unit is not good.
Ambient temperature is too
low.
The ice storage bin is full of
the ice cube.
The temperature of
Ambient, or water in water
tank is too high.
Refrigerant leakage.
Cooling system tube is
clogged.
Move the unit to low temperature
space, or lengthen the time of each
ice making cycle.
Make sure there is more than
20CM space between the unit back
& front and the obstacle.
Reduce the time of each ice
making cycle.
Take out some ice cube.
Move to the place with temperature
lower than 32℃,centigrade, and
change to the low temperature
water.
Need the technical serviceman to
maintain.
Need the technical service person
to maintain.
23