HOMCOM 800-293V70 Bedienungsanleitung Seite 12

EN
It is recommended that a separate circuit, serving only your ice maker, be provided. Use
receptacles that cannot be turned off by a switch or pull chain. If the supply cord or plug
to be replaced, it should be done by a qualified service engineer.
This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good
grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is
equipped with a power supply cord having a grounding plug. To minimize possible shock
hazard, the cord must be plugged into a mating grounding-type wall receptacle,
grounded in accordance with the National Electrical Code and local codes and
ordinances. If a mating wall receptacle is not available, it is the personal responsibility of
the customer to have a properly grounding wall receptacle installed by a qualified
electrician.
CLEANING YOUR ICE MAKER BEFORE FIRST USING
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Open the ice getting door.
2. Clean with diluted detergent, warm water and a soft cloth.
3. Repeatedly clean the water contacting inner parts, you can pull the Water drain pipe of
the water tank indicating "H" in above illustration to drain the cleaned water in the
water tank, then next to clean inner ice-storing cabinet, till all of inner parts are cleanly,
then drain out all of the cleaned water from the water drain port located at unit back
indicating "7"in above illustration. And must to reinstall back the water drain pipe of the
water tank and the cap of the unit water drain port, otherwise, the unit will not make the
ice normally. And suggest that you should discard the ice-cube made by the first ice
making cycle after cleaning.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution
and warm water.
5. Dry the interior and exterior with a clean soft cloth.
WATER CONNECTION FOR YOUR ICE MAKER
Important: Be sure to use the new hose-sets supplied with the appliance to connect to
water mains and that old hose-sets should not be reused.
How to remove the water pipe: Turn off the tap, remove the blue clip on the water valve,
then press the lock and pull the water pipe outwards. Note: Be sure to turn off the tap and
drain the water inside. If the tap is not turned off, it will be difficult to pull out the water
pipe due to water pressure.
1.Connect the water supplying hose to the unit
Step 1:First remove the tape on the water inlet port for water supply (indicated in the
following illustration "B") located at unit back, then use your other hand's finger to press
the out circle
Step 2: Insert the one end of the white water hose into the water inlet port, and push
inward completely, and install back the clipper, then water hose connection is completed.
12