Cleaning And Servicing; Troubleshooting - Bosch MFW4 Serie Gebrauchsanleitung

en
Place a bowl or plate under the outlet

opening.
Insert the mains plug.

Place the food to be processed in the

feed tube.
Insert pusher and hold in place.

Note:
Pusher can be inserted in one direction only.
Note position of the curve!
Switch appliance on with the On/Off

button.
Press food down using the pusher.

Do not exert too much pressure!
After using the appliance:
Switch appliance off with the On/Off

button.
Remove mains plug.

Pull out the pusher.

Remove the shredding attachment.

Holding down the release button, turn the
attachment to the right and remove.
Disassemble shredding attachment.

Clean all parts, see "Cleaning and

servicing".

Cleaning and servicing

Important information
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
Electric shock risk
Never immerse the base unit in liquids and
do not clean in the dishwasher.
Before cleaning the appliance, pull out the
mains plug!
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Do not clean the aluminium parts (housing,
worm gear and threaded ring of the mincer
attachment) in the dishwasher. Harmless
discolouration may occur over time.
16
Cleaning the appliance
Pull out the mains plug.

Wipe the mincer clean with a damp cloth.

If required, use a little detergent.
Cleaning the attachments
Rinse housing, worm gear and threaded

ring of the mincer attachment by hand.
Dry metal parts straight away and apply

a little edible oil to protect them from rust.
Fig.  gives an overview of how to clean

the individual parts.

Troubleshooting

Fault
Appliance stops but does not switch off.
Cause
Appliance overloaded, e.g. mincer blocked.
Remedial action
Switch appliance off and wait until it

comes to a standstill.
Press reverse button to remove the

blockage.
Wait until the drive comes to a standstill.

Switch on appliance again.

Fault
Appliance switches off during use.
Cause
Appliance overloaded. Overload protection
feature has been activated.
Remedial action
Switch off the appliance.

Remove mains plug.

Leave the appliance to cool down for

approx. 60 minutes.
Lift appliance and press the thermal

circuit breaker on the underside of the
appliance (Fig. , 14).
Insert the mains plug.

Switch on appliance again.

Important information
If the fault cannot be eliminated, please
contact customer service.
Robert Bosch Hausgeräte GmbH