Operation - Kärcher BD Trike BAT Betriebsanleitung

English
Tighten the star knobs.
Check that the traction cable functions
correctly.
Attach the suction hose.

Operation

Risk of injury!
!
To stop all functions immediately,
press the red Emergency STOP pushbutton.
Driving
Caution!
Get used to your unit by test-driving
it in an open space.
Drive up/down slopes at low speed only.
Information:
i
The unit has a projecting brush head
on the right side, ensuring a clear view
when cleaning right up to the edge.
Sit on the unit and set the key switch
to "I".
Set the direction of travel with the
"Direction-of-travel" buttons on the
control panel.
Specify the driving speed by depressing
the drive pedal.
To stop the unit: release the drive pedal.
Adjusting the operating speed:
Forwards:
– Press the Info button until "Clean spd
Fwd" is displayed
Reverse:
– Press the Info button until "Clean spd
Rev" is displayed
Press the button for adjusting the opera-
ting speed.
After 5 sec. in drive mode the data is au-
tomatically saved.
Adding detergent
Caution!
Use the recommended detergents
only. If other detergents are used, the
operator increases the risk of malfunctions
and accidents.
Detergents must not contain solvents,
hydrochloric acid or hydrofluoric acid.
Information:
i
Do not use detergents which foam
vigorously.
Before switching on the unit for the first
time, completely fill the fresh-water tank in
order to vent the water line system.
Working without recycling
If cleaning in hygienic areas (e.g. hospitals,
food companies) and if giving very dirty
floors a basic cleaning.
Open the threaded plug on the fresh-
water tank.
Fill with fresh water (maximum 60 °C)
up to the lower edge of the filler inlet
Add detergent.
Comply with the metering information.
Operating Instructions
33