Kärcher BD Trike BAT Betriebsanleitung Seite 35

English
Information:
i
The surface must be cleaned several
times depending on the degree of dirt.
Lowering the suction bar
Unlock the suction bar pedal by gently
pushing it to the right.
The suction bar is lowered and the
suction motor switches on.
Caution!
To clean tiled floors, adjust the
straight suction bar so that it is not at right
angles to the crevices. When the dirty-
water tank is full, the suction turbine
automatically switches off.
Information:
i
To improve the vacuuming result,
the suction bar can be rotated or tilted
(see "Setting the suction bar").
Switching on the brush head
Caution!
To prevent damage to the floor,
do not operate the unit on the spot.
Depress the pedal and unlock by
simultaneously tilting it forwards;
the cleaning head is lowered and the
brush motor starts automatically.
Adjust the brush contact pressure with
the star knob.
Information:
i
Start cleaning at a low contact
pressure. Gradually increase the contact
pressure until the desired cleaning result
is obtained.
A correctly set contact pressure reduces
the energy requirement and brush wear.
If the machine stops, the brush motors
stop. If the brush motors overload, the fuse
trips. In this case, the fuse must be
changed (F2, 70 A).
Caution!
The brush contact pressure must not
be set too high for polishing.
Stand-by
If an operating pause exceeds 30 minutes,
the appliance switches to stand-by.
To restart the appliance, briefly rotate the
key switch to "O" and then back to "I".
Operating Instructions
35