Assembly; Start-Up; Commissioning; Adjusting The Working Position (22, 23) - Al-Ko Bf 5002-R Ii Betriebsanleitung

Assembly

DANGER! Risk of poisoning. The engine
exhaust gases contain carbon monoxide that can
kill a person within a few minutes.
■
Operate the engine only outdoors, never in a
closed room.
■
Do not inhale the engine exhaust gases.
■
Switch off the engine if you feel nauseous,
dizzy or weak when using this appliance. Im-
mediately consult a doctor.
4 ASSEMBLY
Assembly: See figures (02) to (21).
WARNING! Danger if assembly is not
carried out completely! Use of an incompletely
assembled device can result in serious injury.
■
Only use the device when it is fully assem-
bled!
■
Before switching on, check that all safety and
protective devices are in place and function-
ing correctly!
WARNING! Danger of explosion and fire.
Petrol and oil are highly flammable. Fire can lead
to serious injuries.
■
Remove the spark plug connector before as-
sembly.
■
Fill the appliance with oil and petrol only after
complete assembly and only outdoors.

5 START-UP

5.1

Commissioning

Oil and petrol in the engine
IMPORTANT! Engine damage if operated
without oil. Operation of the engine without en-
gine oil will result in serious engine damage!
■
Always comply with the operating instructions
supplied from the engine manufacturer!
■
Fill the engine with oil before putting into op-
eration for the first time!
■
Fill the fuel tank with petrol!
Ground travel gearbox
The gearbox is filled with transmission oil at the
factory.
5.2

Adjusting the working position (22, 23)

Depending on the attachment, the handlebar and
steering column must be swivelled to the respec-
tive working position.
1. Remove the gear shift lever (22/1, 23/1).
443808_a
2. Unscrew the locking lever (22/2, 23/2) until
the teeth of the steering column (22/3, 23/3)
disengage.
3. Swivel the steering column through 180° to
the desired working position either above or
behind the engine (22/4, 23/4) and engage in
the centre teeth.
4. Secure the steering column with the locking
lever again.
5. Fit the gear shift lever again.
Working positions
Above the engine (22/4):
■
Scythe attachment
■
Front scythe mower mechanism
■
Sweeper
■
Snow plough
Behind the engine (23/4):
■
Ridge plough
■
Tiller
5.3 Adjusting the height of the handlebar
(24)
Adjust the height of the handlebar according to
your body height. The normal height adjustment
corresponds to hip height.
1. Loosen the screws (24/1) on the right and left
of the handlebar (24/2).
2. Move the handlebar up or down (24/a). The
slot (24/3) limits the adjustment range.
3. Tighten the screws again.
5.4

Swivelling the handlebar (25)

The steering column (25/1) can be swivelled from
the centre position (25/2) one notch (25/3) to the
right or left (25/a). This allows the appliance to be
guided along the ground from the side (e.g. when
using the ridge plough).
1. Unscrew the locking lever until the steering
column comes out of the notch.
2. Swivel the steering column to the left or right
and allow it to engage in the notch again.
Note: Take care not to trap the Bowden ca-
bles.
3. Tighten the locking lever again until the steer-
ing column is fixed.
Caution! The steering column may only be
screwed tight in one of the 3 predefined lock-
ing positions! Intermediate positions are not
permitted!
®
23