Assembly; Start-Up; Carrying Out Visual Inspection; Providing The Mains Cable And Checking The Mains Connection - AL-KO COMBI-CARE 36.8 E Comfort Betriebsanleitung

Assembly

necessary and restrict the dura-
tion of the work to a minimum.
For your personal protection and
protection of persons in the vi-
cinity, appropriate hearing pro-
tection must be worn.
4 ASSEMBLY
Assembly: See images (01) to (04).
WARNING!
Danger if assembly is
not carried out complete-
ly!
Operation of an incom-
pletely assembled appli-
ance can result in serious
injury.
■
Only operate the appli-
ance when it is fully as-
sembled.
■
Check that all safety
and protective devices
are in place and func-
tioning correctly before
switching on.

5 START-UP

5.1

Carrying out visual inspection

1. Check the appliance for damage and loose
screws. Replace the defective appliance
parts and tighten the screws.
2. Check the mains cable for damage. Replace
the defective mains cable.
3. Check the appliance for coarse soiling. Re-
move soiling.
5.2 Providing the mains cable and checking
the mains connection
Heed the safety instructions for the mains cable
(see chapter 3.1.1 "Electrical safety", page 31).
442246_a
Requirements for the mains cable
Provide a mains cable that complies with the fol-
lowing requirements:
■
3 conductors with a minimum cross-section
of 2.5 mm (i.e. with protective conductor)
■
Maximum length of 40 m
■
Spray water protected (protection category
IP44)
■
Suitable for outdoor use (H05RN-F quality,
i.e. rubber hose cable)
Requirements for the mains connection
Check that the mains connection complies with
the following requirements:
■
Min. 10 A fuse
■
Fault current circuit breaker with max. 30 mA
trigger current

6 OPERATION

NOTE
Always mow the grass before scarifying
(max. grass height: 4 cm).
Remove any foreign bodies from the
grass surface.
6.1

Opening the impact flap ( 05)

The appliance can be operated with or without
grass collector. The grass collector is available
as an accessory.
Scarifying without grass collector
NOTE
The impact flap is closed on delivery. Al-
ways open the impact flap before scari-
fying so that the scarified material can
be discharged at the impact flap.
1. Fold the impact flap (05/1) back until it audi-
bly engages at an angle of approx. 30°.
Scarifying with grass collector
Fold the impact flap completely up. Using the
grass collector: see chapter 6.7 "Attaching and
removing the grass collector [optional] (11)",
page 39.
37