Baumer NE216 Betriebsanleitung Seite 40

NE216
Programming
Preset mode:
Line 22 to 0 = Step preset
Reset mode:
Line 23 to 1
without automatic reset
Output time P1, P2:
Line 41, 42 to pulse or
duration
Preset mode:
Line 22 to 0 = Step preset
Reset mode: Line 23 to 0
with automatic reset
Preset mode:
Line 22 to 1 = Trailing preset
VW (P1) corresponds to the
interval between P1 and P2.
When P2 is changed, P1 is
trailed.
Operation mode:
Line 21 to 2 = OUT P2 at SC,
automatic reset at 0
Preset mode:
Line 22 to 0 = Step preset
Preset mode:
Line 22 to 0 = Step preset
Reset mode: Line 23 to 1
without automatic reset
Function control input 1:
Line 34 to 9
OUT P1 and OUT P2 are
activated by a signal to
control input 1 (Ein St1) and
the count is reset.
40
5.3 Output (output mode)
The behaviour of the signal outputs is defined by the following set-
tings under the programming field 3: Operating mode, preset mode,
reset mode, take-over of presets, output logic and output time P1,
P2 as momentary
The following diagrams illustrate some examples:
Operating mode
Line 21 to 0 = adding
www.baumer.com
or latched signal
Operating mode
Line 21 to 1 = subtracting
.