Programming Mode - Baumer NE216 Betriebsanleitung

Read ➜ Press
„SF" appears for one second on the display. The display then
jumps to the current scaling factor SF .
➜ Enter scaling factor SF via
Modify
The setting range from 0.0001 to 999.99 is attained by shifting
the decimal point. Select decimal point via
➜ Press
By pushing

5 Programming mode

Operation parameters are set on the programming level.
The programming level consists of 3 programming fields.
Access is protected by a 4-digit code.
Programming field 1
Here it is possible to select and modify all operation parameters. The
operation parameters that are disabled for the operator are also dis-
played.
Programming field 2
The individual operation parameters for operator access are disabled
or enabled here.
Programming field 3
All functions and values as well as interface parameters conditioned
by the machinery are programmed here.
Switch on programming
➜ Press
„Code" appears on the display.
No code number has yet been set at the factory, therefore it is
possible to skip the code query by pushing
programming line 50. After a code has been set, it will only be possi-
ble to switch to the programming level by entering the correct code.
www.baumer.com
key.
and
key.
again, the current count is re-displayed.
and key simultaneously.
NE216
.
and shift via
. The code is set on
.
33