Brine Preparation - BWT Rondomat Rondomat RondomatDuo S Bedienungsanleitung

EN EN
EN EN EN
58 58
58 58 58
Check that system has been properly installed
Use AQUATEST to measure and record the
hardness of the drinking water before it enters
the water-softening system.

Brine preparation

Brine preparation Brine preparation Brine preparation Brine preparation
Remove protective hood (2).
Fill 2-4 sacks of regenerant (50-100 kg salt tablets
complying with DIN EN 973 type A, e.g. Clarosal
or Sanisal/Sanitabs) in to the chamber(3 3 3 3 3 ).
The brine chamber (6 6 6 6 6 ) is automatically filled with
drinking water during commissioning.
N.B.: N.B.:
N.B.: If a major soft water withdrawal is envisaged N.B.: N.B.:
after commissioning, it should be noted that the
system requires about three hours for brine to
form.
Insert mains plug. Insert mains plug. Insert mains plug. Insert mains plug. Insert mains plug.
Water supply must remain off.
The display shows the start screen
version number.
Let basic fixing take place. Let basic fixing take place. Let basic fixing take place. Let basic fixing take place. Let basic fixing take place.
The running noise stops after about 40 sec. The running noise stops after about 40 sec.
The running noise stops after about 40 sec. The running noise stops after about 40 sec. The running noise stops after about 40 sec.
start screen start screen with the start screen start screen