Inflating; Compressor Mode - Parkside Pka 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung

˜ Inflating
˜ Compressor mode
The compressor mode is suitable for inflatable articles that need to be inflated at high
pressures, such as beach items, balls, bicycle and car tyres etc. You may need an
adapter.
Selecting the adapter
1. Place the product on a stable and flat surface.
2. Select the desired adapter depending on the object you want to inflate:
Adapter
Tapered adapter
18a ] [
Adapter for bicycle valves
Ball needle
[ 18b ]
3. Remove the compressed air hose
air hose.
4. Fold up the clamping lever
5. Connect the compressed air hose
inflate.
6. Fold down the clamping lever
Setting the unit and pressure
1. Press the On/Off switch
pressure unit on the LCD display
changes between psi, bar and kPa.
2. Set the desired pressure:
– Press the button +
value.
– Press the button −
the value.
The set pressure value is shown on the
display .
[ 7 ]
NOTE
This product is not calibrated! For
u
a calibrated measurement value,
check the actual tyre pressure using
a calibrated meter after you have
inflated the object yourself.
Press and hold the button +/-
u
or to increase or decrease the
3 ] [
pressure display rapidly.
16 GB
18c ] [
from the storage compartment for compressed
[ 14 ]
on the valve connection
[ 12 ]
with the adapter to the object you wish to
[ 14 ]
on the valve connection
[ 12 ]
. The
[ 4 ]
7 ] [
to increase the
[ 5 ]
to decrease
[ 3 ]
5 ] [
Object to be inflated
Inflate swimming accessories, e g :
Paddling pools
o
Air mattresses
o
Boats
o
Bicycle tyres
Balls
.
[ 13 ]
13 ] [
Operation
1. Press the On/Off switch
is ready for use.
2. Set to the desired pressure. (see
Setting the unit and pressure)
3. Press the toggle switch

compressor mode.

article is inflated until the set pressure
is reached.
4. Cancel the pumping process: Set
the toggle switch
position.
to lock it in place.
. The device
4 ] [
towards
6 ] [
The inflatable
to the middle
6 ] [