Checking The Battery's Charging Level; Operation; Switching The Product On/Off; Switching The Led Work Light On And Off - Parkside Pka 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung

Before operation: Charge the
o
battery when it is at medium or
19 ] [
low charging level (see "Checking the
battery's charging level").
The charging control LEDs (red and
o
green) indicate the status of the
charger and the battery
[ 23 ]
LED
Red LED lights up
Green LED lights
up
Green LED and red
LED flashing
Red LED flashing
Green LED lights
up (without battery)
1. Insert the battery
charger .
23 ] [
2. Connect the mains plug of the
charger to a mains outlet.
23 ] [
3. When the battery
– Disconnect the mains plug of the
charger from the mains outlet.
[ 23 ]
– Remove the battery
charger .
23 ] [
˜ Checking the battery's
charging level
(Fig. B)
Check battery's
o
Press the button
The charging level LEDs
charging level as follows:
Charging level LEDs Charging level
Red/orange/green
Red/orange
Red
.
19 ] [
Status
Battery charges
Battery fully
charged
Battery defective
Battery too cold or
too warm
Charger ready
into the
[ 19 ]
is fully charged:
[ 19 ]
from the
19 ] [
charging level:
19 ] [
.
20 ] [
show the
21 ] [
Maximum
Medium
Low
˜ Operation
WARNING! Risk of injury!
m
Wear ear protection!
˜ Switching the product on/off
Switching on
Press the ON/OFF switch
o
display lights up.
[ 7 ]
Switching off
1. Press the on/off switch
5 s until the LCD display
2. Remove the rechargeable battery
from the device if you are leaving the
product unattended or if you have
finished working.
NOTE
The product switches off
u
automatically after a while if it is not
used.
˜ Switching the LED work light
on and off
Requirements
The device is switched on.
o
DANGER!
m
Do not look into the light source.
u
LED button
9 ] [
Press 1 time
Press 2 time
Press 3 time
. The LCD
[ 4 ]
for approx.
4 ] [
goes out.
7 ] [
[ 19 ]
LED work light
[ 10 ]
On - level 1
increase the
brightness
Off
GB 15