Parkside PKA 20-Li D3 Bedienungsanleitung Und Originalbetriebsanleitung Seite 15

h) Keep handles and grasping surfaces
dry, clean and free from oil and
grease. Slippery handles and grasping
surfaces do not allow for safe handling
and control of the tool in unexpected
situations.
Battery tool use and care
a) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
b) Use power tools only with
specifically designated battery
packs. Use of any other battery packs
may create a risk of injury and fire.
c) When a battery pack is not in use,
keep it away from other metal
objects, like paper clips, coins,
keys, nails, screws or other small
metal objects, that can make a
connection from one terminal
to another. Shorting the battery
terminals together may cause burns or
a fire.
d) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
e) Do not use a battery pack
or tool that is damaged or
modified. Damaged or modified
batteries exhibit unpredictable
behaviour resulting in fire, explosion or
risk of injury.
f) Do not expose a battery pack
or tool to fire or excessive
temperature. Exposure to fire or
temperature above 130 °C may cause
explosion.
12 GB
g) Follow all charging instruction and
do not charge the battery pack or
tool outside the temperature range
specified in the instruction. Charging
improperly or at temperatures outside
the specified range may damage the
battery and increase the risk of the fire.
WARNING!
m
Do not dispose of batteries in
household waste, fire or water.
Do not subject the battery
to strong sunlight over long
periods and do not leave it on
a heater (max. 50 °C).
Max. 50°C
Service
a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This
will ensure that the safety of the power
tool is maintained.
b) Never service damaged battery
packs. Service of battery packs
should only be performed by the
manufacturer or authorized service
providers.
Additional safety instructions
Starting the motor is prohibited at low
temperatures below 0 °C.
Avoid heavy loads on the piping
system by using flexible hose
connections to avoid kinks.
WARNING!
m
All hoses and fittings of compressors
u
must be suitable for use at the
maximum permissible pressure.
We recommend providing feed hoses
with a safety cable, e.g. a wire rope, at
pressures above 7 bar.
The maximum inclination of the
compressor is 0 degrees.