Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery; Switching On And Off - Parkside PALP 20-Li B2 Originalbetriebsanleitung

GB IE
Checking the
charge status of the
rechargeable battery
The battery charge status indicator (24a)
signalises the state of charge of the battery
(24).
Press the button (24b) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery (24) when
the red LED on the charge status
indicator (24a) is on.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (24) when
the red LED on the charge status
indicator is on.
1. Remove the battery (24) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (24) in the charging
compartment of the battery charger
(26).
3. Plug the battery charger (26) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (26) from
the mains.
28
5. Remove the battery (24) from the char-
ger (26).

Switching on and off

Cordless air pump
1. To switch the device on, move
the On/off switch (20) to positi-
on "1". The LED work light (19)
lights up.
2. To switch the device off, move
the On/off switch (20) to positi-
on "0".
Switching on the cordless
compressor, variant 1:
1. Press the On/off button (6) on
the display (4) to switch the de-
vice on. The display (4) shows
the preconfigured pressure (see
"Changing the pressure setting").
2. Press the On/off switch (10). The
device turns on.
-> When the preconfigured
pressure is reached, the device
switches off automatically.
3. To start the device again, press
the On/off switch (10) twice.
Switching on the cordless
compressor, variant 2:
1. Press the On/off switch (10) di-
rectly.
- the display switches on,
- the device starts,
-> the device switches off auto-
matically when the preconfi-
gured pressure is reached.
2. To start the device again, press
the On/off switch (10) twice.
If your device does not start by
pressing the on/off switch (10),
either the on/off button (6) must be
pressed on the display (4), or the