VEVOR RLC15 3 Bedienungsanleitung Seite 31

The stirrer is noisy
The material outlet
cannot produce
any the material
The material outlet
cannot produce
any theatrical
1RH/2RH/3RHalar
m
1E, 2E, 3E Rotor
Lock Frozen
Cylinder Alarm
lf the machine failure is not caused by the above reasons or the above
suggestions cannot solve the problem, please contact the sealer.
The bell mouth sealing ring is
not installed properly
The Slush Machine is very
hard
Bell mouth sealing
lubricated or damaged
The raw sugar content is too
low
Too much ice in the bucket
The bucket is not clean
Dirty stirrer seal
Damaged stirrer sea
The corresponding
temperature sensor is broken
The sugar content of the raw
material in the cylinder is too
low. When the sugar content
is in sufficient, the agitator
may trigger a frozen cylinder
protection due
unable to rotate.
The snow melt
temperature is set too low. If
the snow melt has already
formed but does not reach
the set forming temperature,
the agitator may trigger a
frozen cylinder
due to
being unable to rotate.
- 29 -
Check whether the sealing
ring is installed in place
Re-adjust the hardness
not Apply lubricant or replace
with
new one
Re-adjust
ingredients, cannot replace
sugar with sweetener.
Shut down and let the ice
cubes melt
Re-clean
Re-clean
Replace with new sea
bowl Replace
sensor
Increase the sugar content
of the raw material. The
sugar content should be
maintained at 13%-18%.
to being
forming
Adjust
forming
slightly increasing it to an
appropriate level.
protection
the ratio of
the temperature
the snow melt
temperature by