VEVOR RLC15 3 Bedienungsanleitung Seite 24

Assembly of buckets
Lift the front end of the evaporator slightly, and then put the bucket into the
evaporator. Put the rear end of the bucket into the rear sealing ring of the
evaporator, and then continue to push the bucket forward until the front
end of the material barrel is locked into the limit of the bucket seat.
Assembly of material outlet assembly
A. Put the valve stem under the outlet of the bucket.
B. Put the discharge spring down from the top of the bucket outlet and
place it on the valve stem.
C. Insert the front end of the handle into the stem limit slot.
D. Press the card groove on the back of the discharge spring along the
material outlet limit.
E. Adjust the handle rotation hole, the discharge spring upper cover fixing
hole and the material outlet cross pin hole toa line, then pass the cross
pin through, and then tighten the cross-pin nut on the cross pin.
Note: the valve stem sealing ring should be smeared with Vaseline before
the outlet can be installed.
- 22 -