VEVOR RLC15 3 Bedienungsanleitung Seite 15

3. Pour in the raw materials
Note: do not load hot liquid (temperature
more than 24 degrees Celsius).
The raw material should not exceed the
maximum level. line (about 10L) or lower
than the minimum level (about6L).
Mix the ingredients well and pour them into
two cylinders,
4.Close the lid
Warning: only when the machine is turned off or
not plugged in can theraw material be poured
into the bucket.
5.Start the machine
First, plug the machine into the socket, and turn on the power on the operation
panel. Then, turn on the light, stirring 1, Stirring 2 in turn, and finally turn on the
compressor and the machine beginsto work
material of the bucket is formed, the cooling of the cylinder block will be stopped. If
the she bet is not ha d enough, increase the hardness by adjusting the hardness
knob.
Close the lid after the raw
material is
automatically.
- 13 -
After the inner