Troubleshooting Instructions - Vevor Rlc15 3 Bedienungsanleitung

The machine
cannot be turned
on
The material
outlet is leaking
Raw Material is
leaking from the
back of the
bucket
The stirrer can't
turn
The machine does
not make sherbet

Troubleshooting Instructions

No power input
Machine power switch is
not turned on
Parts located at material
outlet are not lubricated
Damaged valve stem seal
Bucket not installed in
place
Bucket seals are not
lubricated
The power switch on the
right side is not turned on
Bucket not installed in
place
Evaporator's surface is
frozen
Low sugar content
The master switch is not
turned on
The sherbet of the serrano is
not adjusted to the right level
The condenser is too dirty
The Slush Machine is close
to the heat source, and the
heat dissipation around it is
poor.
Evaporator freezing cylinder
Excessive alcohol content
- 28 -
Insert the power plug into
a suitable outlet
Turn the power switch on
Lubricate the outlet parts
Replace the stem seal
Check the tank
installation
position
Apply lubricant
Replace the sealing ring
Switch on
Turn off the power switch
and let the ice melt
Turn off the machine for
10 minutes, add more
sugar or concentrate
until a paste-like
substance appears.
Turn on the master switch
Adjust the hardness
sherbet
Clean the condenser
Put the machine in the right
place
The machine starts
freezing cylinder protection,
wait for five minutes The
machine restores cooling by
itself
Add water until a paste
appears
of
the