Safety Thermostat; Cooling Fan - ZANKER ZKB 7630 Bedienungsanleitung

To set the temperature and cooking
time
Press the buttons " " and " " to increase
or decrease the pre-set temperature while the
°
" " symbol is flashing (Fig. 6). The maximum
temperature is 250°C.
Press the buttons " " and " " to increase
or decrease the pre-set cooking time while the
symbol flashes.

Safety thermostat

To prevent dangerous overheating (through
incorrect use of the appliance or defective
components), the oven is fitted with a safety
thermostat, which interrupts the power supply.
The oven switches back on again automatically,
when the temperature drops.
Should the safety thermostat trigger due to
incorrect use of the appliance, simply remedy
the error after the oven has cooled down. If, on
the other hand, the thermostat triggers because
of a defective component, please contact
Customer service.

Cooling fan

The cooling fan is designed to cool the oven
cavity and the control panel. The fan switches
on automatically after a few minutes of cooking.
Warm air is blown out through the slots near to
the oven door handle. The fan may continue to
run after the oven is switched off to cool the ap-
pliance. This is absolutely normal.
The action of the cooling fan will depend
on how long the oven has been used
and at what temperature. It may not
switch in at all at lower temperature
settings or run on if the oven has only
been used for a short time.
Electrolux
Fig. 6
9