ZANKER ZKB 7630 Bedienungsanleitung Seite 30

Electrolux
To perform this operation correctly, pro-
ceed as follows:
a) the decorated middle pane with a frame on the
4 sides must be reassembled so that the screen-
printing is facing outwards. The side of the pane
of glass is correct if you do not feel any roughness
near the screen printing when you pass your
fingers over the surface.
The middle pane of glass must be put back into
the right seats as shown in Fig. 32.
b) the uppermost pane must be reassembled as
shown in Fig. 33.
After the panes of glass have been reassembled
in the oven door, perform the procedure described
in point 8. in reverse to ensure they are locked.
Never clean the oven door when it is
warm as the panels might shatter. If
you can see scratches or cracks in
the glass panel, call your nearest
service centre immediately to have
the panel replaced.
Models in stainless steel or aluminium:
Clean the oven door and operating panel
in stainless steel or aluminium with a damp
sponge and then dry carefully with a soft
cloth. Never use metal pads, metal wool,
acids or abrasives for cleaning because
they may scratch the surfaces.
How to clean the oven door seal
A rubber seal around the oven opening guarantees
correct operation.
Check the condition of this seal periodically.
If it has to be cleaned, do not use abrasive
objects or substances.
If you notice that the seal is damaged,
contact your local service centre and do not
use the oven until it has been repaired.
30
Fig. 33
Fig. 32