ZANKER ZKB 7630 Bedienungsanleitung Seite 27

To programme the pyrolytic cleaning
cycle (delayed start, automatic stop)
If you desire, you can programme the
starting and ending time of the pyrolytic cleaning
cycle.
1. Use the button
Press the button
until the Pyro function symbol
- P I) appears in the display.
Simultaneously the "Pyro indicator and the
symbol will flash in the display and
an acoustic signal will be emitted. This means
that, before activating the pyrolytic cleaning
function, you have to remove all the oven
accessories and the side rails from the oven
cavity (see the previous chapter).
2. The Cooking Time symbol
some seconds; during this time push the
button ' ' or ' ' to select the pyrolytic 1 (P
I) or pyrolytic 2 (P 2) function.
3. Once you have chosen the desired pyrolytic
function, Pyro will flash in the display waiting
for confirmation to start the pyrolytic cleaning
function.
At this time, push the time function button
(Fig. 23). "The End of Cooking" symbol
and the arrow symbol
panel, the cleaning cycle (that is, the actual
time + cooking time) will displayed.
Press the ' ' or ' ' buttons to select the
required end of cycle time (Fig. 23). After a
few seconds, the word Pyro and the symbol
will stop flashing, the acoustic signal
will stop while the Cooking time symbol
will flash until the pyrolytic cleaning cycle
starts.
to switch on the oven.
as often as necessary,
(level 1
will flash for
flash. On the control
4. After some time the door lock will be Activated
and the respective symbol
displayed.
At the end of the pyrolytic cleaning process,
the display shows the time of day. The oven
door is locked.
Once the oven has cooled down, an acoustic
signal will be emitted and the door will unlock.
To stop the pyrolitic cleaning cycle at any
time: press the button
Electrolux
will be
.
Fig. 23
27