Error Codes - ZANKER ZKB 7630 Bedienungsanleitung

2. Press the bottons
time. A short acoustic alarm will be heard and
the time 12:00 appears in the display (Fig.
15).
When the oven is switched on, the symbol
appears in the display.This means that the
demo function is activated.
All oven functions can be selected.
The oven is not really working and the
heating elements do not switch on.
Switch off the oven and follow the above
described procedure to disable the demo mode.
The demo mode remains saved in
the programme in the event of a
power failure.
Beep on touch
You can choose to make the electronic control
beep each time that a button is pressed. To
enable this function, the oven must be off.
1. Press the buttons
and keep them pressed for about 3 seconds.
The alarm signal beeps once (Fig. 16).
To disable the beep on touch:
1. With the oven switched on, press the button
to switch the oven off.
2. Press the buttons
and keep them pressed for about 3 seconds.
The electronic control beeps once.

Error codes

The electronic programmer does a
continuous diagnostic check of the system. If some
parameters are not correct, the control unit will
stop the activated functions and it will display the
corresponding error code (Fig. 17).
For further details, refer to chapter
"Troubleshooting".
and " " at the same
and " " at the same time
and " " at the same time
Electrolux
Fig. 15
Fig. 16
Fig. 17
19