Filling The Water Tank; Set Iron Temperature; Spray Function; Ironing Without Steam - Silvercrest SDB 2400 E3 Bedienungsanleitung

6.1 Filling the water tank

DANGER!
Pull the mains plug 10 out of the socket
before you fill up the water tank 13.
• Use clean tap water without any addi-
tives (e.g. vinegar, limescale remover,
starch, perfume, softener).
• The integrated anti-limescale protection
reduces limescale deposits for average
water hardness, and thus extends the
service life of the device. If your tap wa-
ter is hard, use distilled water. Where
the water is moderately hard, mix dis-
tilled water and tap water at a ratio of
1:1.
1. Disconnect the mains plug 10 from the
wall socket.
2. Set the steam flow rate controller 3 to
.
3. Open the lid 2 (of the water tank) and
tilt the iron forwards slightly to fill it.
4. Use the measuring beaker 19 to pour in
water up to the mark 17 max, but at
least up to one quarter. Hold the steam
iron upright to check.
5. Close the lid 2 (of the water tank).
6. Place the steam iron on the base
unit 12 and set the steam flow rate con-
troller 3 to the desired position.

6.2 Set iron temperature

1. Figure B: Set the desired temperature
using the temperature controller 15:
- MIN the device is not getting hot
÷
- temperature: up to
approx. 110 °C
(synthetic materials - e.g. poly-
ester)
8
GB
÷÷
- temperature: up to
approx. 150 °C
(Silk, wool)
÷÷÷
- temperature: up to
approx. 210 °C
(linen, cotton)
- MAX maximum temperature
2. The temperature control lamp
for as long as the steam iron is heating.
It goes out when the set temperature has
been reached. You can then begin iron-
ing.

6.3 Spray function

Use the spray function in order to dampen
dry items of laundry. This option is available
irrespective of the set temperature. For this
purpose, the water tank 13 must be at least
one quarter full.
• Repeatedly press the spray button 5
While doing so, hold the steam iron
horizontally with the tip over the item of
laundry. Ensure that no water sprays
onto the ground.

6.4 Ironing without steam

Sensitive fabrics are ironed at lower temper-
atures and without steam. In order to damp-
en them, the spray function is available.
1. Set the steam flow rate control 3 to
and set the temperature controller 15 to
MIN.
2. Fill the water tank 13 if you wish to use
the spray function.
3. Place the steam iron on the base
unit 12.
4. Connect the mains plug 10 with the
wall socket.
5. Set the desired temperature using the
temperature controller 15. The tempera-
ture control lamp 7 lights up.
6. Start ironing as soon as the ironing tem-
perature has been reached and the tem-
perature control lamp
7 is lit
.
7 goes out.