Disposal; Packaging; Trouble-Shooting; Technical Specifications - Silvercrest SDB 2400 E3 Bedienungsanleitung

10. Disposal

This product is subject to the
provisions of European Direc-
tive 2012/19/EC. The sym-
bol showing a wheelie bin
crossed through indicates
that the product requires sep-
arate refuse collection in the European Un-
ion. This applies to the product and all
accessories marked with this symbol. Prod-
ucts identified with this symbol may not be
discarded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Re-
cycling helps to reduce the consumption of
raw materials and protect the environment.

Packaging

When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.

11. Trouble-shooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
Do not attempt to repair the device your-
self under any circumstances.
Fault Possible causes/Action
• Connect the device to the
mains power supply.
No
• Use the temperature control-
function
ler 15 to turn up the temper-
ature.
Fault Possible causes/Action
• Fill the water tank 13 to at
least one quarter full.
Little or • Switch on the steam flow
no steam rate controller 3
(
• Run the self-cleaning cycle.
• Fill the water tank 13 to at
Steam
least one quarter full.
burst is
• Set the right temperature.
not work-
• Leave a pause of a few sec-
ing.
onds between steam bursts.
Spray • Fill the water tank 13 to at
burst is least one quarter full.
not work- • For the first spray burst, you
ing. need to pump several times.
The sym- • The safety shut-off has been
activated (see "Safety shut-
bol
off" on page 9).
flashes
12. Technical
specifications
Model: SDB 2400 E3
Mains voltage: 220-240 V ~50/60 Hz
Protection class: I
Power rating: 2,000 - 2,400 W
Subject to technical modification
).
11
GB