Filling The Water Tank; Ending Ironing; Anti-Drip System - Silvercrest SDBE 2600 B2 Bedienungs- Und Sicherheitshinweise

˜ Filling the water tank
m
DANGER! Risk of electric shock! Always
disconnect the power plug 8 from the power
outlet before filling the water tank .
m
ATTENTION! Fill the water tank with tap water
or distilled water without any additives . If your
tap water is hard, use distilled water . Where the
water is moderately hard, mix distilled water and
tap water at a ratio of 1:1 .
m
ATTENTION! Use the measuring cup 14 to fill
water into the water tank .
NOTE: The water tank has a filling capacity of
approximately 370 ml .
NOTE: The max mark 13 that marks the
maximum filling capacity applies when the
product is set up vertically on the base 9 .
1 . Place the product on the base 9 and tip it
forward at approximately 45° .
2 . Open the lid of the fill opening 3 .
3 . Carefully pour water into the water tank . Do not
exceed the max mark 13 .
4 . Close the lid of the fill opening 3 .
Spray function
You can spray the fabric in front of the soleplate
1 with water as required . To do so, press the
spray button 5 .
Steam burst
You can steam the fabric through the soleplate 1
as required . To do so, press the steam button 6 .
NOTES:
You can also use the steam burst in a
vertical position .
The higher the set temperature, the stronger the
steam burst .
Steam ironing
You can also set the iron to continuously give off
steam .
The temperature control 11 should be at the
highest level to produce enough steam .
The steam control 4 has 3 positions:
No
steam
NOTE: Continuous steam ironing is only possible
when the iron is held horizontally . If you hold the
iron vertically or set it down, this interrupts steam
operation .
˜ Ending ironing
1 . Turn the temperature control 11 counter-clockwise
all the way to MIN .
2 . Set down the product with the base 9 on an
even, stable surface .
3 . Disconnect the power plug 8 from the power
outlet .
4 . Let the product cool (this take approximately
15 minutes) . Do not leave the product
unattended while it is still hot .
5 . To prevent limescale build-up, empty the water
tank after each use . To do so, open the lid of the
fill opening 3 . Empty the water tank via the fill
opening 3 by holding the iron upside down over
a sink .
˜ Additional product features
˜ Anti-drip system
The product features an anti-drip system . This
prevents water from exiting from the soleplate 1
as long as the temperature is too low to produce
steam . This feature prevents water stains on your
clothing .
Medium Maximum
steam steam
GB/IE 23