Filling The Water Tank; Plugging In And Ironing - Silvercrest SDBR 420 A2 Bedienungsanleitung

Filling the water tank

1) Place the iron on a level surface .
2) Open the cover on the water tank 1 filler opening .
3) Fill the measuring cup w up to the MAX marking with tap water
and fill this water into the water tank .
4) Close the cover on the water tank 1 filler opening .
5) Raise the iron vertically . You can read off the maximum water
level at the inspection openings 2 .

Plugging in and ironing

Dry ironing without steam is possible at all temperatures; steam
ironing is only possible above the setting range
temperature control 4 .
1) Insert the plug into a mains power socket .
CAUTION! PROPERTY DAMAGE!
► Before you connect the steam iron to the power supply, always
ensure that the correct voltage has been set on the voltage
switch 7 (see section Before first use) .
► If the clothing care instructions forbid ironing (
ment may not be ironed . Ignoring this warning could lead to
permanent damage to the clothing item .
2) Check the care instructions on the garment labels to see if they
are suitable for being ironed and at which temperature setting .
Temperature control symbol 4
SDBR 420 A2
/MAX on the
), the gar-
Material type
Silk, acrylic, rayon
Wool
Cotton, linen
GB │ IE │ NI │ CY │ 11 ■