Ironing With Steam; Steam Jet Function; Safety Shut-Off - Silvercrest SDB 2400 E3 Bedienungsanleitung

7. Finish ironing, set the temperature con-
troller 15 to MIN and pull out the
mains plug 10.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 13 through the filling open-
ing in the water tank (under the lid 2).

6.5 Ironing with steam

Steam ironing requires a high temperature,
at least the temperature setting for
der to additionally dampen items of cloth-
ing, the spray function is also available.
1. Set the steam flow rate control 3 to
and set the temperature controller 15 to
MIN.
2. Fill the water tank 13.
3. Place the steam iron on the base unit 12.
4. Connect the mains plug 10 with the
wall socket.
5. Set the temperature controller 15 to the
desired temperature (at least
temperature control lamp
up.
6. As soon as the ironing temperature has
been reached and the temperature control
lamp 7 goes out, adjust the steam
flow rate controller 3 to the desired steam
flow rate and start ironing.
The steam will ...
... start to come out as soon as you hold
the steam iron horizontal, and
... stop as soon as:
- you hold the steam iron vertically,
- you place the steam iron on the base
unit 12,
- the temperature is too low,
- the water tank 13 is empty
or
- you set the steam flow rate control-
ler 3 to .
7. Finish ironing, set the temperature con-
troller 15 to MIN, set the steam flow
rate controller 3 to
mains plug 10.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank 13 through the filling open-
ing in the water tank (under the lid 2).

6.6 Steam jet function

The steam jet function requires a high tem-
perature. Select a temperature setting be-
. In or- tween and MAX. For this purpose, the
water tank 13 must be at least one quarter
full. The steam flow rate controller 3 is locat-
ed to the left on the symbol
• Press the steam jet button while the
steam iron glides over the item of laun-
dry 4
• Wait a few seconds before you press
the steam jet button 4
NOTE:
• For smoothing items of clothing that are
). The
hanging up, you can use the steam jet
7 lights
Button in a vertical position.

7. Safety shut-off

DANGER! - Fire hazard!
Despite the automatic switch-off, the
steam iron must not be left
unsupervised.
Your steam iron possesses a safety shut-off of
the heating function (AUTO SHUT OFF).
Activating the function
he automatic switch-off occurs, if
- the device has stood still in vertical posi-
tion for approx. 8 minutes.
- the device has stood still on the sole
plate for approx. 30 seconds.
- the device has laid on its side for ap-
prox. 30 seconds.
and pull out the
.
.
again.
GB
9