Noise; Residual Risk - Cor Level System Bedienungsanleitung

Switch off / dissipate energy sources:
The safety regulations applicable to third-party devices are contained in the documents of the
third-party suppliers (operating instructions for purchased units).
Danger from residual energy!
Stored energy can also be present after the table has been switched off.
Residual energy or stored energy must be dissipated by qualified personnel
before working on the table!

3.1 Noise

The A-weighted equivalent continuous sound pressure level at the workstation of this system is
less than 80 dB (A).

3.2 Residual risk

Residual hazards!
When handling the table, there are still residual hazards which could not be
eliminated by the design.
The table is built according to the state of the art and recognised safety regulations. Nevertheless,
its use may result in hazards for the user or third parties.
It is forbidden:
• to remove covers and put protective devices out of operation,
• to continue to operate the table in the event of changes that impair safety,
• to put stress on overload protections beyond the permissible overload path,
• to manipulate or bypass protection devices.
Please note:
• Never remove safety devices or disable them by making changes to the system.
Faults which could impair safety must be rectified immediately.
Before disassembly or opening or before cleaning work, every movement of the machine must be
at a standstill and the mains plug must be disconnected.
• Never reach into the moving actuator of the table.
Reaching into moving actuators can result in crushing and pinching injuries.
Ensure that the actuator can move freely.
Electrical energy:
The table is switched off by disconnecting the mains plug on the
underside.
GB
4 3