Liability; Safety - Cor Level System Bedienungsanleitung

The control unit of the Level Table electric receives the supply voltage of 230V via a power supply
GB
unit. The actuator is driven by mains operation. The movements are controlled via a control panel
on the right side of the table top. The table is moved in jog mode and switches off automatically at
the upper and lower end positions of the travel path.

2.4 Liability

Our liability is limited to damages that occur during normal use as intended. We shall not be liable
for safety defects which are not yet recognisable according to the current state of the art.
Our liability is excluded in the event of violations:
• against safety instructions for the operating personnel,
• against the warnings of special hazards,
• against the prohibition of unauthorised modifications and alterations,
• against the use of spare and wear parts or auxiliary materials not ap-proved by the manufacturer.
We reserve the right to make technical changes in the interests of continuous product improvement
at any time without prior notice.
3 Safet y
The table described in the operating instructions has been built to the latest state of the art and is
safe to operate.
Hazards are secured in accordance with the regulations. However, the system can be dangerous
if it is used by untrained personnel, improperly or for purposes other than those for which it is
intended.
This can pose a risk to health, the system and the functionality of the system.
Every person entrusted with the installation, commissioning, operation or repair of the table
should read the operating instructions, especially the chapter „Safety instructions".
Safety devices must not be altered in any circumstances.
If it becomes necessary to dismantle safety devices during repair work, the safety devices must be
reinstalled immediately after completion of the work.
The table may only be operated in perfect working order. Work requiring specialist knowledge (e.g.
electrical work) may only be carried out by specially qualified and trained personnel.
The table must be disconnected from the power supply before maintenance work is carried out.
Therefore, always observe the following 5 safety rules before starting work on electrical systems:
1. Disconnect the table from the power supply!
2. Secure against being switched on again!
3. Check that there is no voltage!
4. Ground and short-circuit!
5. Cover or shield any adjacent live parts!
4 2