Pre-Assembly Tabletop - Cor Level System Bedienungsanleitung

GB
3 11
Insert the last leg into the cross beam 1 and attach it using the supplied screws and nuts
12
. Tighten the screws securely. The underframe is now fully pre-assembled.
6.3 Pre-assembly of tabletop
Ensure that a sufficiently large, dry and clean assembly surface is available for assembling the
tabletop. Be sure to cover this surface with blankets. Then carefully place the three parts of the
tabletop 4 + 5 on the prepared assembly area with the underside facing upwards.
3 6
Insert and evenly distribute slats per table joint into the groove provided.
4 4