Measuring Conditions; Replacing Internal Batteries - Ht Instruments Idm70 Bedienungsanleitung

5. MEASURING CONDITIONS

Measuring range
The instrument's measuring range is 70m. At night,
under poor visibility conditions or if the surface to be
measured is in shadow, the measuring range can be
reduced. To prevent this, carry out measurements
during the day or use luminous plates when the object
to be measured has poor reflecting properties.
Object surface
The instrument can give errors when measurements
are carried out on colorless liquids (e.g. water),
transparent glass, polystyrene, very polished or half-
permeable surfaces because of the deviation of the
laser beam. Non-reflecting surfaces may cause delays
when measuring.
Maintenance
Do not immerse the instrument in water. To clean the
instrument, use a soft cloth moist with neutral
detergent

6. REPLACING INTERNAL BATTERIES

The instrument is supplied by 2x1.5V AA LR06 alkaline
batteries. When the symbol "
display, it is necessary to replace the batteries.
Proceed as follows:
1. Slide the battery compartment cover to the right and
remove it (see Fig. 14)
2. Remove the batteries and insert the same number
of batteries of the same type, respecting the correct
polarity. Only use alkaline batteries
3. Restore the battery compartment cover into position
by sliding it to the left to fasten it again
Fig. 14: Replacement of the internal battery
EN - 20
iDM70
" flashes on the