Operating Instructions; Initial Operations And Settings; Setting Of Measuring Reference - Ht Instruments Idm70 Bedienungsanleitung

4. OPERATING INSTRUCTIONS

4.1. Initial operations and settings

 Press the
the laser pointer. Press and hold the
switch off the instrument.
 Press the key
shown on the display.
 Press the
Press the keys
delete the temporary memory's content. The value
"00" is shown on the display.
 Press the
backlight of the display.
 Press and hold the
for setting distance measuring units. Cyclically press
the key to select the options: "m", "ft", "in" and
"ft+in"

4.2. Setting of measuring reference

In order to perform correct measurements, it is
important
reference on the instrument by pressing the
Possible options are:
 Top  measurement is carried out by the upper
part of the instrument.
 Bottom  measurement is carried out by the lower
part of the instrument and therefore also the whole
instrument length is considered (default condition)
"Bottom" reference
key to switch on the instrument and
key to see the saved distance values.
key to activate/deactivate the
to define
to clear (CLR) the last datum
and at the same time to
key to activate the section
beforehand
EN - 8
the measuring
"Top" reference
iDM70
key to
key.