Area Measurement - Ht Instruments Idm70 Bedienungsanleitung

4.6. Area measurement

This measurement allows calculating the area of
surfaces expressed in m
1. With the instrument in stand-by, press the
or the side MEAS key to select the desired type of
reference (see § 4.2)
2. Press the
measuring section. The symbol "
the display with side "1" flashing
3. Press the
perform the first measurement (length) of the
surface concerned (see Fig. 7). The corresponding
value appears on the first partial display. The
symbol "
flashing
4. Press the
perform the second measurement (width) of the
surface concerned (see Fig. 7). The corresponding
value appears on the second partial display, while
the (up-to-date) total value of the area appears on
the resulting display
5. Measuring result is automatically saved in the
instrument's memory
Fig. 7: Example of area measurement
2
, in
key to enter the Area/Volume
key or the side MEAS key to
" appears on the display with side "2"
key or the side MEAS key to
EN - 12
2 2
or ft
iDM70
key
" appears on