Volume Measurement - Ht Instruments Idm70 Bedienungsanleitung

4.7. Volume measurement

This measurement allows calculating the volume of
solids expressed in m
1. With the instrument in stand-by, press the
to select the desired type of reference (see § 4.2)
2. Press the
measuring section. The symbol "
the display with side "higher" flashing
3. Press the
perform the first measurement (length) of the
surface (see Fig. 8). The corresponding value
appears on the first partial display. The symbol "
appears on the display with side "1" flashing
4. Press the
perform the second measurement (width) of the
surface (see Fig. 8). The corresponding value
appears on the second partial display. The value of
the corresponding area is shown on the resulting
display. The symbol "
with side "2" flashing
5. Press the
perform the third measurement (height) (see Fig.
8). The total value of volume is shown on the main
resulting display
6. Measuring result is automatically saved in the
instrument's memory
Fig. 8: Example of volume measurement
3 2
, in or ft
key twice to enter the Area/Volume
key or the side MEAS key to
key or the side MEAS key to
key or the side MEAS key again to
EN - 13
3
" appears on the display
iDM70
key
" appears on
"