Behncke Basic I Betriebsanleitung Seite 21

2.3 Sources of danger
Work may only be carried out on the whole system if the system is shut down and unplugged from the mains.
2.4 Hazards from accessories
Only BEHNCKE accessories may be used. Accessories must not endanger the safety of the system.
2.5 Safety measures at the installation site
The filter control system must be installed in a dry room and is not suitable for use in constant sunlight.
Only run the system if all the safety devices are fully functional. The system and its surroundings
may be damaged.
2.6 Safety devices
Warning signs indicate there are risks due to the electric current.
CAUTION!
The control system may only be used:
• for its intended use.
• when it is in perfect condition from a safety and technical perspective.
• In the event of malfunctions which may impair safety, you must disconnect
the system from the mains and consult an electrician.
It's about your safety!
CAUTION!
The electrical equipment in the system is under high voltage. As a result,
please observe the following instructions:
• Work may only be carried out on the electrical equipment by electricians.
• The electrical equipment in the system must be inspected regularly.
• Loose connections and damaged components must be secured
or replaced immediately.
Disconnect the system from the mains before carrying out maintenance
work. There is a risk of injury and damage to the system. Never remove safety
devices or put them out of operation by modifying the system.
Behncke Basic I + II / Safety
4