The Operator's Responsibilities; Personnel Requirements; Qualification; Approved Operators - Behncke Basic I Betriebsanleitung

Behncke Basic I + II / Safety

2.7 The operator's responsibilities

The control system is used in the private sector.
The operator must:
• be trained in the use of the system.
• have read and understood this manual – in particular the chapter on safety and the warnings.
• For safety reasons, the operator must integrate a ground fault circuit interrupter into
the power supply.
• store the system away from frost over winter.

2.8 Personnel requirements

2.8.1 Qualification

The following qualifications are mentioned in the instruction manual for various fields of activity:
• Trained person
has been given training by the operator on the tasks assigned to them and the possible dangers if they do
not carry out these tasks properly.
• Specialist
is able to carry out the tasks assigned to them and to identify possible dangers on their own thanks to their
specialist training, knowledge and experience, as well as their knowledge of the relevant regulations.
• Electrician
is a person who can assess the work assigned to them and identify possible dangers thanks to their
specialist (electrical) training, knowledge and experience, as well as their knowledge of relevant standards
and regulations.

2.8.2 Approved operators

The control system may only be operated by people who:
• are physically and mentally suitable for this purpose
• are trained in its use
• have read and understood this manual – in particular the chapter on safety and the warnings.
5
WARNING!
Risk of injury for those insufficiently qualified!
• Improper handling may result in significant personal injury or material
damage.
• Specific tasks may only be carried out by the people named in the
respective chapters of this operating manual.
• Keep unqualified people away from the danger zones.