Herunterladen Diese Seite drucken

Scheppach DS200 Originalbetriebsanleitung Seite 33

Trockenbauschleifer
Vorschau ausblenden Andere Handbücher für DS200:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
12. Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
13. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product does not start
Product does not operate
with full power
Poor operation results
Considerable dust formation
Possible cause
Power supply interrupted
Power cord or plug defective
Other electrical defect of the product
Extension cord too long and/or cross-
section too small
Power supply (e.g. generator) voltage
is too low
Accessory worn out
Sanding plate worn out
Dust extraction not connected/
switched on
www.scheppach.com
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Check power supply by connecting
another product
Have an electrician check the tool
Have an electrician check the tool
Use extension cord with permissible
length and/or adequate cross-section
Connect product to an appropriate
power supply
Have accessory replaced
Have sanding plate replaced
Connect / switch on dust extraction
GB | 33

Werbung

loading

Diese Anleitung auch für:

5903802901