Scheppach BTS700 Originalbetriebsanleitung Seite 23

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for dam-
age to the device or caused by the device arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised spe-
cialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions for
safe, proper and economic operation of the device, for
avoiding danger, for minimising repair costs and down-
times, and for increasing the reliability and extending the
service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations applica-
ble to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed with
respect to the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country, the
generally recognised technical rules relating to the oper-
ation of such machines must also be observed.
We accept no liability for accidents or damage that occur
due to a failure to observe this manual and the safety
instructions.
2. Product description (Fig. 1-2)
1. Sanding belt
2. Sanding belt table
3. Sanding guard
4. Disc sanding belt (Velcro fastening)
5. Adjustable sanding table
6. Sanding table adjustment
7. On/off switch
8. Engine
9. Sanding belt adjustment screw
10. Extraction nozzle for disc sanding
11. Extraction nozzle for belt sanding
12. Mitre gauge
3. Scope of delivery (Fig. 3)
• Belt and disc sander (a)
• Sanding belt table (2)
• Extraction nozzle for belt sander (10)
• Mitre gauge (12)
• Adjustable sanding table (5)
• Clamp bolt M6 2x (b)
• Washer Ø6 2x (c)
• Phillips screw M4x10 3x (d)
• Washer Ø4 3x (e)
• Clamping lever M8 1x (f)
• Washer Ø8 1x (g)
• Operating manual
4. Proper use
The purpose of the belt and disc sander is to sand all
types of wood, depending on the size of the machine.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or injuries
of any type resulting from this.
An element of the intended use is also the observance of
the safety instructions, as well as the assembly instruc-
tions and operating information in the operating manual.
www.scheppach.com GB | 23