Scheppach BTS700 Originalbetriebsanleitung Seite 30

- Further supplementary take-back conditions of the
manufacturers and distributors can be obtained
from the respective customer service.
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can arrange
for the free collection of the old electrical device upon
request from the end user. Please contact the manu-
facturer's customer service for this.
• These statements only apply to devices installed and
sold in the countries of the European Union and which
are subject to the European Directive 2012/19/EU.
In countries outside the European Union, different
regulations may apply to the disposal of waste electri-
cal and electronic equipment.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not start.
Machine becomes
slower during work.
Sanding belt comes off
the drive pulleys.
Wood gets burnt during
sanding.
30 | GB
Possible cause
On/off switch damaged
On/off cable damaged
On/off relay damaged
Fuse burnt
Motor burnt
Too much pressure is
applied to the workpiece.
It does not run straight.
Sanding disc or sanding belt
is covered with grease.
Excessive pressure was
applied to the workpiece.
www.scheppach.com
Remedy
Replace all damaged parts before you use your sanding
machine again.
Contact your local service centre or an authorised
service station. Every attempt to carry out a repair, can
be dangerous if it is not done by skilled personnel.
Apply less pressure to the workpiece.
Reset the track.
Replace belt or disc.
Reduce the pressure applied to the workpiece.