Scheppach AB1600 Originalbetriebsanleitung Seite 25

Additional handle:
Vibration emission value a
Vibration emission value a
Vibration emission value a
Uncertainty K = 1,5 m/s
2
Additional information for electric tools
m WARNING!
The specified vibration emission value has been meas-
ured according to a standardised testing procedure
and can be used for comparison of one power tool with
another; and may change depending on the way in
which the power tool is used and in exceptional cases
may be higher than the specified value. The specified
vibration emission value can be used to compare one
power tool with another.
The specified vibration emission value can also be
used for an initial estimation of the impair.
Keep the noise level and vibration to a minimum!
• Only use faultless devices.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
• Wear gloves.
8. Unpacking
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
= 16.89 m/s
2
h
= 18.43 m/s
2
h
= 18.13 m/s
2
h, Cheq
www.scheppach.com
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
9. Before commissioning
Before connecting the machine, make certain that the
data on the type plate matches with the mains power
data.
Always pull out the mains plug before carrying out ad-
justments on the device.
• Familiarise yourself with your machine. Familiarize
yourself with its use and limitations, but also with the
specific potential hazards.
• Make sure that the switch is OFF before inserting
the plug into the socket.
• Make sure that the machine has been cleaned and
lubricated properly.
• Before commissioning, check the machine for dam-
aged parts and determine whether these parts func-
tion properly and fulfil their intended function. In cas-
es of doubt, the part in question must be replaced.
• Check the alignment of all moving parts, any broken
or fastening parts, and any other conditions which
may impede proper operation. Any damaged part
must be repaired or replaced by a specialist imme-
diately.
• Do not use the machine if a switch cannot be
switched on and off properly.
m ATTENTION! Before the start of operation, check
the deployment location for hidden electrical lines, gas
pipes and water pipes using a cable detector.
10. Working instructions
• Only use faultless devices.
• Make all machine settings with the machine
switched off.
• Never leave the machine unattended when it is run-
ning.
• When shutting down, only leave the machine after it
has come to a complete standstill.
• Always switch the machine off before unplugging the
mains plug.
• Always unplug the mains plug. Never pull the plug
out of the socket using the cable.
• Maintain and clean the device at regular intervals.
GB | 25