Connecting The Dust Extraction; Mounting The Rip Fence; Overload Warning; Adjusting The Cutting Angle - Parkside Performance Pptsa 20-Li B2 Originalbetriebsanleitung

GB MT
The­motor­unit­stops­at­the­point­where­
you can mount/change the saw blade
through the cut-out in the protective
hood (24).
Removing the saw blade
4. Press the spindle lock (37) and loosen
and remove the screw (39) and the
flange­(38)­with­the­large­hex­key­(16)­
(from the auxiliary handle (1)).
5. Carefully remove the saw blade (27)
from the bottom of the protective hood
(24).
Installing the saw blade
4. Place the saw blade (27) from below in
the protective hood (24) on the spindle.
The­marked­running­direction­
on the saw blade (27) must cor-
respond with the marked run-
ning direction on the protective hood
(24).
5.­ Place­the­flange­(38)­on­the­saw­blade­
(27).
6.­ Press­the­spindle­lock­(37)­and­fix­the­
flange­(38)­and­the­saw­blade­(27)­
with the screw (39) using the large hex
key (16).
WARNING!­The­arrow­on­the­saw­
blade must match the direction ar-
row (direction of travel, marked on
the protective hood).
Make­sure­that­the­saw­blade­is­
suitable for the speed of the tool.
Connecting the dust
extraction
Connect a approved dust and shavings
extraction directly or with adapter (40)
to the chip ejector (4).
38
When working with materials that
produce dangerous dust, connect
the device to an appropriate, tested
dust­class­M­suction­device.

Mounting the rip fence

1.­ Loosen­the­butterfly­screw­(11)­for­the­
parallel guide holder (41) and insert
the parallel guide (30) in the parallel
guide holder (41).
2.­ the­desired­cutting­width.­Use­a­metre­
for this if necessary.
The­recesses­(25)­on­the­front­edge­of­
the saw table (10) indicate the cutting
edge for the cutting angle settings 0°
and 45° (see detail picture).
3­ Tighten­the­wing­screws­(11)­of­the­par-
allel guide holder (41).

Overload warning

•­ If­the­device­is­in­danger­of­being­dam-
aged, the overload warning indicator
( 21)­lights­up­(briefly).­The­device­
turns off.
Adjusting the cutting
angle
You­can­determine­the­cutting­angle­using­
the cutting angle scale (13).
1. Loosen the two wing screws (7) of the
cutting angle preselection.
2. Set the desired angle on the cutting an-
gle scale (13) based on the top edge
of the reference mark (12).
3.­ Tighten­the­wing­screws­(7)­again.
To­set­a­mitre­angle­of­-1°­or­+47°,­
turn the adjusting knob (14) after
swivelling.