Additional Instructions; Residual Risks - Parkside Performance Pptsa 20-Li B2 Originalbetriebsanleitung

from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may­cause­burns­or­fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes,
seek medical assistance. Leaking bat-
tery­fluid­may­cause­skin­irritations­or­
burns.
e) Do not use damaged or altered
batteries. Damaged­or­altered­batter-
ies can be unpredictable and lead to
fire,­explosion­or­risk­of­injury.
f) Do not expose batteries to fire
or elevated temperatures. Fire or
temperatures­over­130 °C­can­cause­
an explosion.
g) Follow all instructions for charg-
ing and never charge the bat-
tery or the battery-powered tool
outside the temperature range
stated in the operating instruc-
tions. Incorrect charging or charging
outside the permitted temperature
range may destroy the battery and in-
crease­the­risk­of­fire.
6) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This­will­ensure­that­the­safety­
of the power tool is maintained.
b) Never repair damaged batter-
ies. All battery repairs should be car-
ried out by the manufacturer or author-
ised customer service centres only.

Additional instructions

a) Do not use grinding discs.
b) Select the right saw blade based
on the material you will saw.
Saw blades that are intended for cut-
ting wood or similar materials must
comply­with­EN­847-1.­Only­use­the­
saw for cutting wood, plastic and light-
weight materials
c) Only use saw blades with a
speed designation that meets
the specified speed for your ap-
pliance or higher.
d) Only use saw blades with a di-
ameter of 140 mm corresponding
to the markings on the saw blade.
e) Make sure the tips of the saw
teeth do not overheat.
f) When sawing plastic, make sure
the plastic does not melt.
g) Pay attention to the maximum
cutting depth. (see technical
data)
h) When sawing, wear a dust
mask.
i) Always wear hearing protection!
j) Do not use any accessories (see
section "Spare parts/accesso-
ries") that are not recommended
by PARKSIDE. This­can­result­in­elec-
tric­shock­or­fire.

Residual risks

Even­if­properly­operating­and­handling­
this electric tool, some residual risks will
remain.­Due­to­its­construction­and­build,­
this electric tool may present the following
hazards:
a) Cuts
b)­ Ear­damage­if­working­without­ear­pro-
tection.
c)­ Damage­to­your­health­caused­by­
GB MT
33