Scheppach SM200L Originalbetriebsanleitung Seite 27

Attention!
If the disc/wheel should jam while working, please re-
move your workpiece and wait until the device has
reached its maximum speed again.
Changing the grinding disc
Attention: To prevent injuries caused by accidentally
starting the bench grinder, always switch off the device
(switch setting to "0") and disconnect the mains plug
from the socket before changing the grinding disc.
• Loosen the spark protection and protective panel
and pull them out as far as possible, but do not
detach them.
• Loosen the tool support and pull it out as far as
possible.
• Undo the screws of the grinding wheel guard (6) and
remove the guard.
• Remove the outer flange and the old grinding disc,
put on the new grinding disc.
Note:
• Do not remove the cardboard discs attached to the
sides of the new grinding disc, as these help to safe-
guard the flanges' grip against the grinding disc.
• Inspect the new grinding disc for cracks or other
visible damage and discard if necessary.
• Replace the flange and nut.
• Do not overtighten the nut with a screwdriver, oth-
erwise the grinding disc may break.
• Re-install the grinding wheel guard (6) in the re-
verse order.
• Adjust the tool support, spark protection and pro-
tective panel again according to the assembly in-
structions.
9. Cleaning and maintenance
Disconnect the mains plug before carrying out any
cleaning work.
Cleaning
• Keep protective devices, air vents and the motor
housing free from dust and dirt. Rub the device
clean with a clean cloth or blow it off with com-
pressed air at low pressure.
• We recommend cleaning the device directly after
every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior. Water penetrating
an electric device increases the risk of an electric
shock.
Maintenance
The device has no further internal parts that require
maintenance.
Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Abrasives
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer's mains connection as well as the ex-
tension cable used must also comply with these
regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
www.scheppach.com GB | 27