Gloria MultiBrush speedcontrol PLUS Betriebsanleitung Seite 29

RZ_MULTIBRUSH_SC_DE_GB_FR_NL_IT_DK_ ES_CZ_SE_979646-05.qxp_Text_GB 26.07.24 11:21 Seite 29
8 Maintenance & Cleaning
CAUTION
RISK OF BURNS CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or com-
ponents can still be very hot and may
cause burns.
important to observe the following
safety instruction:

Wear protective gloves during
maintenance and cleaning!
8.1 Cleaning
DANGER
RISK OF DEATH DUE TO ELECTRIC
SHOCK!
If the energised device comes into
contact with water, there is a risk of
seri ous injury or death! You should
therefore observe the following safety
instructions:

Switch off the device and disconnect
the power cord (D) from the power
supply.

Do not immerse the device in water
or spray or clean it with water.
The device must be protected
against moisture. However, if the
device does fall into water, immedi-
ately unplug the mains plug. Never
reach into the water if the device is
still connected!

Clean the outside of the device with a
damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.

Ensure that the ventilation slots are free
of dirt.

In cases of heavier soiling of the roller
brush and/or joint brush units,
dismantle for thorough cleaning (see
Assembly/Disassembly as described in
Chapter 6.1.2). Clean the brushes in
water or with a strong water jet and a
hard brush.

Only use original GLORIA spare parts
for repairs.
It is therefore
29

Repairs must be carried out by a
GLORIA service point.
8.2 Wear of the brushes
NOTE!

If the surface brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.

If the joint brush wears down to a
diameter of ø approx. 90 mm, it must
be replaced.
9 Disposal & Legislation
9.1 Environmental protection &
disposal of the device

These symbols on the product, user
manual or packaging indicates that this
product must not be disposed of in reg-
ular household waste at the end of its
service life.

Do not dispose of electrical appli-
ances through household waste! In
accordance with European Directive
2012/19 / EU on old electrical and elec-
tronic appliances and its implementa-
tion in national law, electrical tools that
are no longer suitable for use must be
separately collected and sent for envi-
ronmentally responsible recycling.
Recycling alternative for the return
request: Alternatively, the owner of an
electric or electronic appliance is obli-
gated to cooperate in proper recycling
in the event of a property task instead
of returning. Old equipment can also
be handed over to a collection facility
car- rying out disposal as defined on
the national recycling and waste man-
agement laws.
This does not apply to the accessories and
auxiliaries included in old equip- ment,
which do not contain electrical compo-
nents.