Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Test/SiIence
Button
The test/silence button is used to test the unit's electronics and to silence the unit during an alarm.
Short pressthe test button and you will hear a short beep, indicating that the alarm has entered the test mode. A test push
notification will be sent to your smartphone by the app. Pleaserefer to the "AlarmTesting" section for further information. The
alarm goes back to the standby mode after testing.
NOTE:After a test has begun, the alarm will sound and the LED indicator will flash red. This does not indicate that CO is
present. Ifyou press the test button during an alarm state, the unit will enter the silence mode.
CO Alarm
Levels
This X Sensecarbon monoxide alarm is programmed to sound an alarm at the following CO concentrations within the time
periods listed:
30 ppm over 120 minutes,
50 ppm for 60—90 minutes,
100 ppm for 10—40 minutes,
and 300 ppm for 0—3minutes.
When CO is detected and the alarm sounds, the COconcentration wil be displayed on the LCDand a blue backlight wil be lit.
The LEDindicator will flash red and the alarm will issue4 short beeps,repeating the cycleevery 5.8 seconds.An alarm push
notification will be sent to your smartphone by the app.
• 04 •
CO Concentration
and Symptoms
The table below showsthe effects of different levelsof COpoisoning on the body:
Parts per Million (PPM)
Effects
on Adults
Slight headache,nausea,fatigue (flu like symptoms).
100
Dizziness
and headache
200
Nausea,frontal headache,drowsiness,confusion and rapid heart rate.
Riskto life after over 3 hours of exposure.
Severeheadaches,convulsions,vital organ failures. Death possiblewithin 2-3 hours.
A WARNING
THIS
DEVICE
IS DESIGNED
TO PROTECT
INDIVIDUALS
NOT FULLY SAFEGUARD INDIVIDUALS WITH SPECIFIC MEDICAL CONDITIONS. IF IN DOUBT, CONSULT A MEDICAL
PRACTITIONER.
within
2-3
hours,
FROM ACUTE
EFFECTS OF CARBON
MONOXIDE
EXPOSURE.
• 05 •
IT MAY
Werbung
