x-sense XC04-WX Bedienungsanleitung Seite 7

Add a Carbon Monoxide Alarm
1.Tap •O" in the right top corner of the app homepage, seect "Carbon Monoxide Alarms', then select "Wi Fi COAlarms" and tap
"Next" to add a device.
2. Removethe insulating film to power up the alarm.
3. Enter a name for the alarm. Selectthe home you created or create a new home for the alarm, then select the room in which it is
installed. f you create a new home, you wil need to enter a name and select the country or region in which you live.
4 Pressand hold the test/silence button on the alarm for 3 seconds until it flashesblue. mmediately tap "Operation Confirmed"
before the light goes off; or else you need to repeat the step to makethe LEDindicator flash blue.
NOTE:If your mobile phone finds two or more devices waiting to connect to the network, you need to tap to select the
corresponding device you want to add.
5. Connect to a 2.4 GHzWi Fi network and make sure you enter the correct password.Then, the alarm will enter the pairing
process. Makesure the test/silence button (the LEDindicator) is stil flashing blue; or else you need to pressit to make it flash
blue again.
6. When finished, you will see the Wi-Fi COalarm on the app's device list,
.10.
The LED indicator
will flash blue
NOTE:
•If your router supports a dual band network with both 2.4 GHz and 5 GHz,please create separate SSIDsfor the
2.4 GHz and 5 GHz channels. This device is only compatible with a 2.4 GHz Wi-Fi network.
• TOpromote successful Wi-Fi connection, make sure you place the alarm within the router range, and that you enter
the correct password.
Press and hold for 3 seconds
.11.